![Looking for ideas to increase bed adhesion. I use PLA on an Ender 3 Pro with a glass bed at 70 C, I clean the bed with IPA before each print. : r/3Dprinting Looking for ideas to increase bed adhesion. I use PLA on an Ender 3 Pro with a glass bed at 70 C, I clean the bed with IPA before each print. : r/3Dprinting](https://i.redd.it/rwqm1hr8mho41.jpg)
Looking for ideas to increase bed adhesion. I use PLA on an Ender 3 Pro with a glass bed at 70 C, I clean the bed with IPA before each print. : r/3Dprinting
![Bad print bed adhesion of white PLA, no problems with transparent uncolored PLA? - 3D Printing Stack Exchange Bad print bed adhesion of white PLA, no problems with transparent uncolored PLA? - 3D Printing Stack Exchange](https://i.stack.imgur.com/FngJU.jpg)
Bad print bed adhesion of white PLA, no problems with transparent uncolored PLA? - 3D Printing Stack Exchange
![Can't get anything to stick to textured print bed – Hardware, firmware and software help – Prusa3D Forum Can't get anything to stick to textured print bed – Hardware, firmware and software help – Prusa3D Forum](https://i.imgur.com/55LOQfg.jpg)
Can't get anything to stick to textured print bed – Hardware, firmware and software help – Prusa3D Forum
![My PLA bed adhesion is simply not good enough for this model, any advice would be greatly appreciated : r/prusa3d My PLA bed adhesion is simply not good enough for this model, any advice would be greatly appreciated : r/prusa3d](https://i.redd.it/gwfbllabs3681.jpg)